Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

09.06.2025 04:08

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

So, the voltage could go up to 500 volts, and the fuse will not open up.

so, what happens?

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

New Non-Opioid Drug Offers Powerful Pain Relief Without the Dangerous Side Effects - SciTechDaily

2024–10–14 [Omar Gharbi Omar Gharbi ]

Because the load is inductive, the current lags the voltage.(by a bit).

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

Wicked: For Good trailer transports fans back to Oz - BBC

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

but I think this circuit , shows a few more pieces.

Barnstars:

Delta Force selection is originally based on SAS selection, so why is there no brutal jungle phase for Delta Force? It seems like it's based only on the Brecon Beacons section.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

eight

At one ohm, the resistor has a maximum of 1 watt power.

Hailee Steinfeld & Josh Allen marry in west coast ceremony - Buffalo Rumblings

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

This is 'the assistant's answer'

But it can get overloaded, and no longer works.

Trump Media Gets Closer to Truth Social Bitcoin ETF Debut With SEC Filing - Decrypt

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

What does a fuse do?

How can I earn money through OnlyFans?

(Dc diagram shown, AC is similar).

The other is “what does a “fuse” do?”

The MOV will conduct when the voltage exceeds 50% of line voltage.

If you caught a shoplifter at your yard sale, how would you handle it?

There are two important concepts here.

It also is a device that limits the change in current flow.

what exactly is a ‘surge’ protector?

Is the Philippines PH a poor 3rd world or 4th world country forever and forever?

a photo is worth a thousand words.

For this case there are devices called Metal oxide varistors (MOV).

At least they know the answer if they wanted it.

Why is the band Nickelback unliked so much?

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

Edit 2024–10.

the problem then depends on "how fast does the fuse operate?".

Big Bang May Not Be The Beginning of Everything, New Theory Suggests - ScienceAlert

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

There are three different concepts here that are getting confused.

What are the best items to buy from a furniture shop?

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

2024–10–16 [ OO OLAOYE OYEBODE ]

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

This Cat Poop Parasite Can Decapitate Sperm—and It Might Be Fueling Infertility - Gizmodo

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

FDA rushed out agency-wide AI tool—it’s not going well - Ars Technica

In schematic diagrams this is the symbol for a fuse:

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

These devices are installed between the “hot” and “neutral” and protective ground.

Robots run out of energy long before they run out of work to do − feeding them could change that - The Conversation

This one hit behind the barn.

Can the fuse protect the electronic devices from lightning instead of a surge protector.

One is “what exactly is in a ‘surge protector’ ? ”

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

A fuse is a non-resetable over current circuit protector.

The bolt then partially travels down the line to your home.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

He then describes the function of a fuse.

Now when you have a certain ac resistance, then a current flows in a loop.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

but this device (an Inductor) … impedes the rapid changes in the current.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

Here is a simplified AC power diagram.

This device then solves the entire problem.

These are simplified answers to the original question, and does not change anything I wrote above.

But… the neutral is now “floating” because of the 1 ohm resistance.

It seems Mohan does not understand the difference between a comment and an Answer.

Upvotes:

[image of Common-mode choke]

This is where the MOV conducts again, and dissipated the energy.

First Sentence:

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

A circuit breaker is similar, but is resettable.

nine

This is the picture of an electronic coil of wire wound around a core of magnetic material.

I post the exact comment here.

One

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

An AC voltage/ current source, and an ac inductive load.

This is where this question deviates from being a 'generic' question, and becomes more specific.

What is lightning?

He then asserts :

2024–10–10[John johnson John Johnson ]

He then describes Rainy Season and Lightning.

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

The third is lightning and “how it gets conducted into a home.”

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

[old diagram got deleted by accident]

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).